The ST-LINK / V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers
5V, 3.3V offers in the same time, allowing you to program your target board with both 5V and 3.3V
500MA internal resettable fuse, complete protection of your expensive computer motherboard!
Red and blue color LED indicator, allowing you to always observe ST-LINK V2 working condition!
Supports For ST-LINK V2
ST-LINK Utility 2.0 and above
STVD 4.2.1 and above
STVP 3.2.3 and above
IAR EWARM V6.20 and above
IAR EWSTM8 V1.30 and above
KEIL RVMDK V4.21 and above
Note
Due to being a copy (Clone) of this program, the consequences of any downgrade and firmware upgrade are the responsibility of the customer.
Also disconnect from the computer after working with the programmer.
Connection with STLINK V2 and STM32F103C8T6
How to install the driver for STLINK V2
To start using this programmer, the first thing you must do is install the driver for this programmer to be recognized by your computer, in this case I will explain how to install the driver for computers that have WINDOWS 7, 8 and 10, perform the following steps:
1- Download the ST-LINK driver
2-Connect the STLINK to the computer.
3- Open the “Device Manager” of windows and verify the status of the driver, it will come out as follows:
4- Since you downloaded the driver and verified the status of the driver, unzip the driver file and run the application called dpinst_amd64 for 64Bit systems and for 32Bits run the application dpinst_x86 .
5- Check again in device manager the status of the controller and if it appears as shown in the image, STLINK is ready.